Installing Regency Faux Panels™ into Concrete

Shop by Style

Brick

Rock / Stone

Wood

Other

Shop by Product

Panels / Siding

Corners

Ledgers

Window / Door Trim

Columns / Posts

Mailboxes

Accessories

Shop by Panel Line

Wellington Panels

Carlton Panels

Regency Panels

Norwich Panels

Oxford Panels

Cambridge Panels

Windsor Panels

Nailon Siding

Novi Siding

York Siding

Log Siding

Raised Grain Panels

Woodland Panels

Shop by Column Line

Ashford Columns

Wellington Columns

Carlton Columns

Norwich Columns

Windsor Columns

Installing Regency Faux Panels™ into Concrete

Regency Faux panels™ are versatile indoors and out, and after a trouble-free installation will add the stunning look of real stone, brick or rock to any surface. Specific, detailed instructions for installing Regency faux panels™ over a concrete surface will ensure that your project goes off without a hitch. All tools and equipment necessary to the project are provided.

1. Always keep the "Positive Lip" of the panel up.

2. Apply a PL construction adhesive to the back of the panel.

3. Apply Regency Panels, color-matched caulk to the positive lip before anchoring.

4. Roto-hammer the pilot hole before for inserting or screwing concrete anchors.

5. Photo showing a forstner type bit for countersinking anchor hole and one of many types of concrete anchors.

6. Drive concrete anchor to a depth of 1/8" below flush.

7. Apply Regency Panels, color-matched caulk to the anchor hole.

8. The final look.

MAKE SURE to observe and obey all safety rules and recommendations set forth by tool manufacturers
and local, state, and federal authorities for any building project including all applicable building codes.

Installing Regency Faux Panels™ into Concrete

How helpful was this page?