Installing Windsor Window/Door Trim

Download this page as a printable PDF

Tools and Supplies You'll Need

  1. A saw for cutting panels at 15° angle – a circular saw, jig saw, band saw, or table saw, it is your preference. Any woodcutting blade used with these saws work great and cut smooth and easy.
  2. Screws
  3. Screwdriver or Screw gun with the appropriate tip for the screws being used.
  4. Tape Measure
  5. Level

Directions:

1.) Attaching Accessories

Windsor FauxPanels® are designed to work with accessory pieces.

Accessory pieces make the job go smoother with professional results.

With accessories, there are no exposed edges and no caulking required.

2.) DoorTrim Attachment

Use a level when locating Door Trim.

Measure Total height of the wall before the ledger attachment.

3.) Mitering the Trim Piece

Cut the top of the piece on a 15 degree angle, with the long side of the angle against the wall.

4.) Attach the Trim Piece

Toe Screw the piece through the top and down along the inside edge, making sure to attach securely to the underlying substrate.

5.) The Final Look.


Important Info...

MAKE SURE to observe and obey all safety rules and recommendations set forth by tool manufacturers and local, state, and federal authorities for any building project including all applicable building codes.


How helpful was this page?
Your rating:
| | | | |
Your comments (optional):
Your e-mail (optional):
(Privacy Policy)

Too hard to read? Click to refresh.
Enter text from picture above: